LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Fuel Injector Sight Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Injector Sight Shield
    GM1201072Courtesy of GENERAL MOTORS CORP.
  1. Remove the cross car brace, if necessary. Refer to Cross Vehicle Brace Replacement (DX) .
  2. Clean the fuel injector sight shield at the power steering and engine oil fill cap locations.
  3. Remove the power steering and engine oil fill caps.
  4. Lift the sight shield up from the front and pull forward to disengage the rear tab from the bracket.
  5. Remove the front compartment sight shields, if necessary. Refer to Front Compartment Sight Shields Replacement .
scientia non olet · About LEMON Manuals