LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Fuel Injector Sight Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Injector Sight Shield
    GM1201072Courtesy of GENERAL MOTORS CORP.
  1. Install the front compartment sight shield, if necessary. Refer to Front Compartment Sight Shields Replacement .
  2. Align the rear tab with the slot in the rear bracket and push the sight shield inward to engage.
  3. Push the sight shield down and align the ball studs on the engine with the holes in the sight shield.
  4. Install the power steering and engine oil fill caps.
  5. Install the cross car brace, if necessary. Refer to Cross Vehicle Brace Replacement (DX) .
scientia non olet · About LEMON Manuals