LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Engine Support Fixture >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Lift Hook & Bracket Assembly At Longitudinal Mounted Cross Bar
    GM682301Courtesy of GENERAL MOTORS CORP.
  1. Unscrew the lift hooks (1) and remove them from the lift bracket and the support brackets. Remove the lift hooks from the tube assemblies.
  2. Remove the front tube and support assemblies from the main support beam.
  3. Remove the main support beam assembly.
  4. Remove the J 28467-15  from the right cylinder head.
    5. NOTE: Refer to Fastener Notice .
  5. Install the front wire harness bracket bolt.

    Tighten:  Tighten the wire harness bracket bolt to 45 N.m (33 lb ft).

  6. Remove the J 28467-86  from the left cylinder head.
  7. Install the push pin securing the wiring harness to the left cylinder head.
  8. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals