LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Oil Pressure Switch
    GM1261656Courtesy of GENERAL MOTORS CORP.
  1. Install a new O-ring on the oil pressure switch.
    2. NOTE: Refer to Component Fastener Tightening Notice .
  2. Install the oil pressure switch to the oil filter adapter.

    Tighten:  Tighten the oil pressure sensor and/or switch to 16 N.m (12 lb ft).

    3. Fig 2: View Of Oil Filter Adapter
    GM1346212Courtesy of GENERAL MOTORS CORP.
  3. Install the oil filter adapter. Refer to Oil Filter Adapter Replacement .
scientia non olet · About LEMON Manuals