LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Engine Mount Replacement - Right Side (w/AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Mount Lower Retaining Nuts
    GM1067552Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

  3. Install the right engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side (w/RWD)  or Engine Mount Bracket Replacement - Right Side (w/AWD) .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals