LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Camshaft Position Actuator Replacement - Bank 2 (Left Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Camshaft Sprockets & Related Components
    GM1276768Courtesy of GENERAL MOTORS CORP.
  1. Remove the left intake camshaft position actuator oil control valve (10). Refer to Camshaft Position Actuator Oil Control Valve Replacement - Bank 2 (Left Side) Intake .
  2. Pull the actuator forward to disengage the camshaft alignment pin from the actuator.
  3. Disengage the secondary timing chain from the actuator and remove the actuator.
scientia non olet · About LEMON Manuals