LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Camshaft Position Actuator Replacement - Bank 1 (Right Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Camshaft Sprockets & Related Components
    GM1276769Courtesy of GENERAL MOTORS CORP.
  1. Remove the right intake camshaft position actuator oil control valve (2). Refer to Camshaft Position Actuator Oil Control Valve Replacement - Bank 1 (Right Side) Intake .
  2. Pull the actuator forward to disengage the actuator from the camshaft alignment pin.
  3. Disengage the secondary timing chain from the actuator and remove the actuator.
  4. Clean and inspect the camshaft timing drive components. Refer to Camshaft Timing Drive Components Cleaning and Inspection .
scientia non olet · About LEMON Manuals