LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Camshaft Cover Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Applying Sealant To Split Line Of Right Cylinder Head & Camshaft Position Actuator Housing
    GM1242793Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be careful to prevent the exposed section of the camshaft cover seal from being damaged by the edge of the cylinder head casting.
  1. Install the camshaft cover gasket as required.
  2. Place a small amount of sealant at the split line (1, 2) of the right cylinder head and the right camshaft position actuator housing. Refer to Sealers, Adhesives, and Lubricants for the correct part number.
    3. Fig 2: View Of Right Camshaft Cover & Bolts
    GM928273Courtesy of GENERAL MOTORS CORP.
  3. Install the camshaft cover.
    4. Fig 3: View Of Ground Strap, Right Camshaft Cover & Bolt
    GM928269Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the camshaft cover bolts installing the ground strap to the camshaft cover.

    Tighten:  Tighten the camshaft cover bolts to 10 N.m (89 lb in).

  5. Install the ignition module. Refer to Ignition Control Module Replacement - Bank 1 for the 4.6L engine.
  6. Connect the cable harness clips to the front of the camshaft cover.
  7. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    8. Fig 4: View Of Right Cylinder Head Wiring Harness Bracket Bolts
    GM887932Courtesy of GENERAL MOTORS CORP.
  8. Install the bolts securing the wire harness bracket to the cylinder head.

    Tighten:  Tighten the wire harness bracket bolts to 45 N.m (33 lb ft).

  9. Install the front air deflector. Refer to Front Air Deflector Replacement .
  10. Lower the vehicle.
    11. Fig 5: View Of Battery Tray
    GM1296149Courtesy of GENERAL MOTORS CORP.
  11. Install the battery tray. Refer to Battery Tray Replacement .
    12. Fig 6: Identifying Lower Bolt Securing Battery Tray To Panel Assembly
    GM1332265Courtesy of GENERAL MOTORS CORP.
  12. Install the front air inlet housing panel. Refer to Air Inlet Housing Front Panel Replacement .
    13. Fig 7: View Of PCV Dirty Air Breather Tube
    GM928153Courtesy of GENERAL MOTORS CORP.
  13. Connect the PCV dirty air tube to the camshaft cover.
    14. Fig 8: View Of Fuel Injector Sight Shield/Top Cover
    GM1272602Courtesy of GENERAL MOTORS CORP.
  14. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals