LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Supercharger Inlet Duct Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove front section of the supercharger inlet duct. Refer to Supercharger Inlet Duct Assembly Replacement .
  2. Loosen the screw clamps on the supercharger inlet duct seals.
  3. Fig 1: Supercharger Inlet Duct Seals
    GM1640656Courtesy of GENERAL MOTORS CORP.
  4. Remove the supercharger inlet duct seals (2).
  5. Fig 2: Rear Section Of Supercharger Inlet Duct
    GM1652890Courtesy of GENERAL MOTORS CORP.
  6. Remove the rear section of the supercharger inlet duct assembly. Refer to Supercharger Inlet Duct Assembly Replacement .
  7. Loosen the screw clamp on the supercharger inlet duct seal.
  8. Remove the supercharger inlet duct seal.