LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Supercharger Inlet Duct Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Rear Section Of Supercharger Inlet Duct
    GM1652890Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the supercharger inlet duct seal and clamp to the throttle body.

    Tighten the supercharger inlet duct seal screw clamp.

    Tighten:  Tighten the supercharger inlet duct seal screw clamp to 2.5N.m (20 lb in).

  2. Install the rear section of the supercharger inlet duct assembly. Refer to Supercharger Inlet Duct Assembly Replacement .
    3. Fig 2: Supercharger Inlet Duct Seals And Clamps
    GM1640656Courtesy of GENERAL MOTORS CORP.
  3. Install the supercharger inlet duct seals and clamps (2) to the front section of the supercharger inlet duct.
  4. Tighten the screw clamps on the supercharger inlet duct seals.

    Tighten:  Tighten the supercharger inlet duct seal screw clamps to 2.5N.m (20 lb in).

  5. Install the front section of the supercharger inlet duct. Refer to Supercharger Inlet Duct Assembly Replacement .
scientia non olet · About LEMON Manuals