LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of ECM
    GM1269407Courtesy of GENERAL MOTORS CORP.
  1. Install the ECM to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ECM mounting nuts (2).

    Tighten:  Tighten the nuts to 8 N.m (71 lb in).

  3. Connect the ECM electrical connectors (1).
    4. Fig 2: View Of Front Air Deflector And Push Pin retainers
    GM699902Courtesy of GENERAL MOTORS CORP.
  4. Install the front air deflector. Refer to Front Air Deflector Replacement .
  5. Lower the vehicle.
  6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  7. Program the ECM. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals