LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left Intake CMP Actuator Solenoid
    GM1239397Courtesy of GENERAL MOTORS CORP.
  1. Remove the remote power steering reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement (LH2) or Remote Power Steering Fluid Reservoir Replacement (LY7) .
  2. Disconnect the actuator solenoid electrical connector.
  3. Remove the left intake camshaft position (CMP) actuator solenoid bolts.
  4. Remove the left intake CMP actuator solenoid.
scientia non olet · About LEMON Manuals