LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Mechanical - 4.6L (LH2) - 5 Of 5) >> Off-Vehicle Repair Instructions (Part 4) >> Starter Installation - Off Vehicle

Starter Installation - Off Vehicle

WARNING: This page is about a different variant/trim than selected.
  1. If installing a NEW starter motor, transfer the cables from the old starter motor.
  2. Install the positive battery cable to the starter motor stud.
    3. NOTE: Refer to Fastener Notice .
  3. Install the starter motor stud nut.

    Tighten:  Tighten the starter motor stud nut to 9.5 N.m (84 lb in).

  4. Install the solenoid wiring harness to the starter solenoid stud.
  5. Install the starter solenoid stud nut.

    Tighten:  Tighten the starter solenoid stud nut to 3.4 N.m (30 lb in).

    6. Fig 1: View Of Starter Motor
    GM928212Courtesy of GENERAL MOTORS CORP.
  6. Position the starter motor in position.
  7. Install the starter motor bolts.

    Tighten:  Tighten the starter motor bolt to 30 N.m (22 lb ft).

    8. Fig 2: Crankshaft Position Sensor O-Ring
    GM1761746Courtesy of GENERAL MOTORS CORP.
  8. Install a NEW O-ring on the crankshaft position sensor.
    9. Fig 3: View Of Crankshaft Position Sensor & Bolt
    GM928205Courtesy of GENERAL MOTORS CORP.
  9. Install the crankshaft position sensor.
  10. Install the crankshaft position sensor bolt.

    Tighten:  Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).

    11. Fig 4: View Of Knock Sensors
    GM928196Courtesy of GENERAL MOTORS CORP.
  11. Install the knock sensors.
  12. Install the knock sensor bolts.

    Tighten:  Tighten the knock sensor bolts to 10 N.m (89 lb in).

    13. Fig 5: View Of Knock & Crankshaft Position Sensor Wiring Harness
    GM928189Courtesy of GENERAL MOTORS CORP.
  13. Install the knock and crankshaft position sensor wiring harness.
  14. Connect the knock and crankshaft position sensor wiring harness brackets to the center, back and front of the block valley.
    15. Fig 6: Locating Knock & Crankshaft Position Sensor Wiring Harness Bolt
    GM928184Courtesy of GENERAL MOTORS CORP.
  15. Install the knock and crankshaft position sensor wiring harness bolt (1).

    Tighten:  Tighten the knock and crankshaft position sensor wiring harness bolt to 10 N.m (89 lb in).

  16. Connect the knock and crankshaft position sensor wiring harness to the knock sensors and crankshaft position sensor.
    17. Fig 7: View Of ECT Sensor
    GM1346202Courtesy of GENERAL MOTORS CORP.
  17. Install the ECT sensor to the right cylinder head.

    Tighten:  Tighten the ECT sensor to 20 N.m (15 lb ft).

scientia non olet · About LEMON Manuals