Power Steering Pump Installation - Off Vehicle

Tools Required 

J 25033-C  Pulley Installer

Fig 1: View Of Power Steering Pump
Courtesy of GENERAL MOTORS CORP.
1. Place the power steering pump in position to the engine.
NOTE: Refer to Fastener Notice .
2. Loosely install the power steering pump side bolt.
Fig 2: View Of Power Steering Pump Front Mounting Bolt
Courtesy of GENERAL MOTORS CORP.
3. Loosely install the power steering pump front bolt.
4. Tighten the power steering pump bolts.

   Tighten:  Tighten the power steering pump bolts to 50 N.m (37 lb ft).

Fig 3: View Of Power Steering Pulley
Courtesy of GENERAL MOTORS CORP.
5. If removed, place power steering pulley in position to the power steering pump.
Fig 4: View Of J 25033-C
Courtesy of GENERAL MOTORS CORP.
6. Install the J 25033-C  into the threads of the power steering pump shaft. Ensure the J 25033-C  threads completely into the shaft of the power steering pump before the pressing components of the J 25033-C  contact the power steering pulley.
Fig 5: Measuring Axial Tolerance Of Power Steering Pulley On Pump
Courtesy of GENERAL MOTORS CORP.
7. Tighten the nut on the J 25033-C  until the hub of the power steering pulley is flush with the end of the power steering pump shaft.
8. Remove the J 25033-C  .