Exhaust Manifold Installation - Right Side (RWD) - Off Vehicle

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Right Engine Mount Bracket - RWD

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the right engine mount bracket.
Install the right engine mount bracket bolts.
Tighten: Tighten the engine mount bracket bolts to 60 N.m (44 lb ft).

Fig 2: View Of Right Engine Mount - RWD

Courtesy of GENERAL MOTORS CORP.

Install the right engine mount.
Install the right engine mount upper nut.
Tighten: Tighten the engine mount upper nut to 80 N.m (59 lb ft).

Fig 3: View Of Right Exhaust Manifold Studs

Courtesy of GENERAL MOTORS CORP.

Install the right exhaust manifold studs to the right cylinder head.
Tighten: Tighten the exhaust manifold studs to 6 N.m (53 lb in).

Fig 4: View Of Right Exhaust Manifold Gasket

Courtesy of GENERAL MOTORS CORP.

Fig 5: View Of Right Exhaust Manifold

Courtesy of GENERAL MOTORS CORP.

Install the right exhaust manifold.
Loosely install the right exhaust manifold bolts and nuts to the right cylinder head.

Fig 6: Exhaust Manifold Bolts & Nuts Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

Tighten the exhaust manifold bolts and nuts in the sequence shown.
Tighten: Tighten the exhaust manifold bolts and nuts to 25 N.m (18 lb ft).

Fig 7: View Of Right Exhaust Manifold Heat Shield

Courtesy of GENERAL MOTORS CORP.

Install the right exhaust manifold heat shield.
Install the right exhaust manifold heat shield bolts.
Tighten: Tighten the exhaust manifold heat shield bolts to 10 N.m (89 lb in).