Exhaust Manifold Installation - Left Side - Off Vehicle

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Engine Flywheel Housing Left Cover

Courtesy of GENERAL MOTORS CORP.

Fig 2: View Of Left Engine Mount Bracket

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the left engine mount bracket bolts.
Tighten: Tighten the engine mount bracket bolts to 60 N.m (44 lb ft).

Fig 3: View Of Left Engine Mount

Courtesy of GENERAL MOTORS CORP.

Install the left engine mount.
Install the left engine mount upper nut.
Tighten: Tighten the engine mount upper nut to 80 N.m (59 lb ft).

Fig 4: View Of Left Exhaust Manifold Studs

Courtesy of GENERAL MOTORS CORP.

Install the left exhaust manifold studs to the left cylinder head.
Tighten: Tighten the exhaust manifold studs to 6 N.m (53 lb in).

Fig 5: View Of Left Exhaust Manifold Gasket

Courtesy of GENERAL MOTORS CORP.

Fig 6: View Of Left Exhaust Manifold

Courtesy of GENERAL MOTORS CORP.

Fig 7: Exhaust Manifold Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

Tighten the exhaust manifold bolts and nuts in the sequence shown.
Tighten: Tighten the exhaust manifold bolts and nuts to 25 N.m (18 lb ft).

Fig 8: View Of Left Exhaust Manifold Heat Shield

Courtesy of GENERAL MOTORS CORP.

Install the left exhaust manifold heat shield.
Install the left exhaust manifold heat shield bolts.
Tighten: Tighten the exhaust manifold heat shield bolts to 10 N.m (89 lb in).