LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Mechanical - 4.6L (LH2) - 5 Of 5) >> Off-Vehicle Repair Instructions (Part 4) >> Engine Wiring Harness Assembly Installation - Off Vehicle >> Right Side Harness Connections

Right Side Harness Connections

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Right Side Fuel Injectors Engine Wiring Harness Connectors
    GM927838Courtesy of GENERAL MOTORS CORP.
  1. Connect the engine wiring harness to the right side fuel injectors.
    2. Fig 2: View Of Right Camshaft Cover Engine Wiring Harness Connectors
    GM927778Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness to the right camshaft cover.
    3. Fig 3: View Of Engine Wiring Harness & Right Ignition Coil Harness
    GM927822Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness to the right coil assembly harness.
    4. Fig 4: View Of Right Camshaft Position Sensors Engine Wiring Harness Connectors
    GM927790Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness to the right camshaft position sensors.
    5. Fig 5: View Of Intake Manifold Stud Engine Wiring Harness Ground
    GM927871Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness ground to the intake manifold stud.
    6. NOTE: Refer to Fastener Notice .
  6. Install the engine wiring harness ground nut.

    Tighten:  Tighten the engine wiring harness ground nut to 10 N.m (89 lb in).

    7. Fig 6: View Of ECT Engine Wiring Harness Connectors
    GM927819Courtesy of GENERAL MOTORS CORP.
  7. Connect the engine wiring harness to the ECT sensor at the rear of the right cylinder head.
    8. Fig 7: View Of Generator Engine Wiring Harness Connectors
    GM1346050Courtesy of GENERAL MOTORS CORP.
  8. Connect the engine wiring harness to the generator.
    9. Fig 8: View Of Generator Starter Motor Wiring Harness Connector
    GM1346047Courtesy of GENERAL MOTORS CORP.
  9. Connect the starter motor wiring harness to the generator.
  10. Install the starter motor wiring harness generator nut.

    Tighten:  Tighten the starter motor wiring harness generator nut to 10 N.m (89 lb in).

    11. Fig 9: View Of MAP Sensor Engine Wiring Harness Connector
    GM927850Courtesy of GENERAL MOTORS CORP.
  11. Connect the engine wiring harness to the MAP sensor.
    12. Fig 10: View Of Knock & Crankshaft Position Sensor Wiring Harness Engine Wiring Harness Connector
    GM927798Courtesy of GENERAL MOTORS CORP.
  12. Connect the engine wiring harness to the knock and crankshaft position sensor wiring harness.
    13. Fig 11: View Of Engine Block Engine Wiring Harness Connector
    GM1346053Courtesy of GENERAL MOTORS CORP.
  13. Install the engine wiring harness bracket to the side of the right cylinder head.
  14. Install the engine wiring harness bracket bolts.

    Tighten:  Tighten the engine wiring harness bracket bolts to 45 N.m (33 lb ft).

scientia non olet · About LEMON Manuals