LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Mechanical - 4.6L (LH2) - 5 Of 5) >> Off-Vehicle Repair Instructions (Part 4) >> Drive Belt Tensioner Installation - Off Vehicle >> P/S Pump and A/C Compressor Drive Belt Tensioner

P/S Pump and A/C Compressor Drive Belt Tensioner

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of P/S Pump & A/C Compressor Drive Belt Tensioner
    GM1346197Courtesy of GENERAL MOTORS CORP.
  1. Place the P/S pump and A/C compressor drive belt tensioner in position to the camshaft position actuator housing. Ensure to properly locate the dive belt tensioner anchor pin in the recess in the camshaft position actuator housing.
    2. NOTE: Refer to Fastener Notice .
  2. Install the P/S pump and A/C compressor drive belt tensioner bolt.

    Tighten:  Tighten the P/S pump and A/C compressor drive belt tensioner bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals