LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Mechanical - 4.6L (LH2) - 5 Of 5) >> Off-Vehicle Repair Instructions (Part 4) >> Drive Belt Installation - Off Vehicle >> Inner Drive Belt

Inner Drive Belt

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Belt Tensioner & Pulleys
    GM284263Courtesy of GENERAL MOTORS CORP.
  1. Insert a 1/2 inch drive extension into the inner drive belt tensioner.
  2. Push down on the extension in order to allow the installation of the inner drive belt.
    3. Fig 2: View Of Inner Drive Belt
    GM1346183Courtesy of GENERAL MOTORS CORP.
  3. Route the inner drive belt around the crankshaft balancer inner pulley, the generator pulley and the inner drive belt tensioner pulley.
  4. Ensure the inner drive belt is properly seated in all the pulleys.
  5. Slowly release the inner drive belt tensioner back to its original position. This will apply tension to the inner drive belt.
  6. After installation, inspect the inner drive belt for proper routing and the correct alignment.
scientia non olet · About LEMON Manuals