LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Mechanical - 4.6L (LH2) - 5 Of 5) >> Off-Vehicle Repair Instructions (Part 4) >> Drive Belt Idler Pulley Installation - Off Vehicle

Drive Belt Idler Pulley Installation - Off Vehicle

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Belt Idler Pulley
    GM1346188Courtesy of GENERAL MOTORS CORP.
  1. Place the drive belt idler pulley in position to the engine.
    2. NOTE: Refer to Fastener Notice .
  2. Install the drive belt idler pulley bolt.

    Tighten:  Tighten the drive belt idler pulley bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals