LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Mechanical - 4.6L (LH2) - 4 Of 5) >> Off-Vehicle Repair Instructions (Part 3) >> Water Outlet Housing Assemble - Off Vehicle

Water Outlet Housing Assemble - Off Vehicle

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Coolant Air Bleed Fitting
    GM1254547Courtesy of GENERAL MOTORS CORP.
  1. Install NEW O-rings on the EVAP purge valve and MAP sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the coolant fitting.

    Tighten:  Tighten the engine coolant air bleed fitting to 10 N.m (89 lb in).

    3. Fig 2: View Of Heater Hose Fitting
    GM1254544Courtesy of GENERAL MOTORS CORP.
  3. Install the heater hose fitting.

    Tighten:  Tighten the heater hose fitting to 45 N.m (33 lb ft).

    4. Fig 3: View Of Bypass Hose
    GM1254542Courtesy of GENERAL MOTORS CORP.
  4. Install the NEW bypass hose.
  5. Position the bypass hose clamp.
    6. Fig 4: View Of MAP Sensor
    GM1254541Courtesy of GENERAL MOTORS CORP.
  6. Install the MAP sensor.
  7. Install the MAP sensor bolt.

    Tighten:  Tighten the MAP sensor bolt to 10 N.m (89 lb in).

    8. Fig 5: View Of EVAP Purge Valve
    GM1254539Courtesy of GENERAL MOTORS CORP.
  8. Install the EVAP purge valve.
  9. Install the EVAP purge valve bolt.

    Tighten:  Tighten the EVAP purge valve bolt to 10 N.m (89 lb in).

    10. Fig 6: View Of Intake Manifold Plenum Duct
    GM1041032Courtesy of GENERAL MOTORS CORP.
  10. Install the intake manifold plenum duct.
  11. Tighten the intake manifold plenum duct clamp.

    Tighten:  Tighten the intake manifold plenum duct clamp to 2.25 N.m (20 lb in).

scientia non olet · About LEMON Manuals