LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Mechanical - 4.6L (LH2) - 4 Of 5) >> Off-Vehicle Repair Instructions (Part 3) >> Intake Manifold Disassemble - Off Vehicle

Intake Manifold Disassemble - Off Vehicle

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Intake Manifold-To-Cylinder Head Gaskets
    GM1012862Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the intake manifold-to-cylinder head sealing gaskets.
  1. Remove and discard the intake manifold-to-cylinder head gaskets.
    2. Fig 2: View Of Sight Shield Retainer Ball Studs
    GM1254532Courtesy of GENERAL MOTORS CORP.
  2. Remove the sight shield retainer ball studs.
    3. Fig 3: View Of Manifold Vacuum Source Cap
    GM1254534Courtesy of GENERAL MOTORS CORP.
  3. Remove the manifold vacuum source cap.
    4. Fig 4: View Of Vacuum Boost Fitting
    GM1254538Courtesy of GENERAL MOTORS CORP.
  4. Remove the vacuum boost fitting.
scientia non olet · About LEMON Manuals