Engine Front Cover Installation - Off Vehicle

WARNING: This page is about a different variant/trim than selected.

Fig 1: Split Line Of The Upper And Lower Crankcase

Courtesy of GENERAL MOTORS CORP.

Place a small amount of sealant GM P/N 12378521 (Canadian P/N 88901148) or equivalent at the split line of the upper and lower crankcases (1).

Fig 2: Engine Front Cover Gasket

Courtesy of GENERAL MOTORS CORP.

Fig 3: Upper And Lower Crankcase

Courtesy of GENERAL MOTORS CORP.

Place a small amount of sealant GM P/N 12378521 (Canadian P/N 88901148) or equivalent at the engine front cover gasket pad area located on top of the split line of the upper and lower crankcases (1).

Fig 4: Engine Front Cover

Courtesy of GENERAL MOTORS CORP.

Place the engine front cover in position on the crankcase.
Apply the thread locking compound GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the engine front cover bolts.
Install the engine front cover bolts.

Fig 5: Engine Front Cover Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Tighten the engine front cover bolts in the sequence shown.
Tighten: Tighten the engine front cover bolts in proper sequence to 15 N.m (11 lb ft).

Fig 6: Water Pump Pulley

Courtesy of GENERAL MOTORS CORP.

Install the water pump pulley.
Install the water pump pulley bolts.
Tighten: Tighten the water pump pulley bolt to 10 N.m (89 lb in).