LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Mechanical - 4.6L (LH2) - 4 Of 5) >> Off-Vehicle Repair Instructions (Part 3) >> Engine Front Cover Assemble - Off Vehicle

Engine Front Cover Assemble - Off Vehicle

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Front Cover Fitting
    GM1346220Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the engine front cover fitting.

    Tighten:  Tighten the engine front cover fitting to 25 N.m (18 lb ft).

    2. Fig 2: View Of Thermostat Gasket
    GM1254524Courtesy of GENERAL MOTORS CORP.
  2. Install the NEW thermostat gasket onto the thermostat.
    3. Fig 3: View Of Thermostat
    GM1254523Courtesy of GENERAL MOTORS CORP.
  3. Install the thermostat and gasket into the thermostat housing.
    4. Fig 4: View Of Thermostat Housing
    GM1254521Courtesy of GENERAL MOTORS CORP.
  4. Install the thermostat housing.
  5. Install the thermostat housing bolts.

    Tighten:  Tighten the thermostat housing bolts to 10 N.m (89 lb in).

    6. Fig 5: View Of Water Pump O-Ring
    GM1403356Courtesy of GENERAL MOTORS CORP.
  6. Install the NEW water pump O-ring.
    7. Fig 6: View Of Water Pump
    GM1040709Courtesy of GENERAL MOTORS CORP.
  7. Install the water pump.
  8. Install the water pump bolts.

    Tighten:  Tighten the water pump bolts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals