Camshaft Position Actuator Housing Installation - Right Side - Off Vehicle: Notes

Tools Required 

EN 46109  Guide Pin Set

Fig 1: View Of Right Camshaft Position Actuator Housing
Courtesy of GENERAL MOTORS CORP.
NOTE: DO NOT remove the camshaft position actuator magnet unless it needs to be replaced. The camshaft position actuator magnet is precisely aligned to the camshaft position actuator oil control valve on the end of the camshaft during engine assembly. If the camshaft position actuator magnet is removed and/or needs to be replaced, it will be necessary to realign the camshaft position actuator magnet to the camshaft position actuator oil control valve after the camshaft position actuator housing is installed to the cylinder head. Failure to realign the camshaft position actuator magnet to the camshaft position actuator oil control valve can lead to poor engine performance and engine component damage.
1. Install the right camshaft position actuator housing.
Fig 2: Locating Right Camshaft Position Actuator Housing Studs
Courtesy of GENERAL MOTORS CORP.
NOTE: Refer to Fastener Notice .
2. Install the right camshaft position actuator housing short studs (345) and long studs (346).

   Tighten:  Tighten the right camshaft position actuator housing studs to 10 N.m (89 lb in).

Fig 3: View Of Right Intake Camshaft Sensor & Right Exhaust Camshaft Sensor
Courtesy of GENERAL MOTORS CORP.
3. Install the right camshaft position sensors.
4. Install the right camshaft position sensor bolts.

   Tighten:  Tighten the right camshaft position sensor bolts to 10 N.m (89 lb in).