LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Engine Mechanical - 4.6L (LH2) - 3 Of 5) >> Off-Vehicle Repair Instructions (Part 2) >> Engine Block Cleaning and Inspection - Upper - Off Vehicle >> Cylinder Bore Diameter Measurement Procedure

Cylinder Bore Diameter Measurement Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Measuring Cylinder Bore Diameter
    GM287937Courtesy of GENERAL MOTORS CORP.
  1. Measure the cylinder bore diameter at 41 mm (1.61 in) below the cylinder block deck surface using the J 8087  .
  2. Compare the results with the engine mechanical specifications. If the cylinder diameter exceeds the specifications, the cylinder block must be replaced. There are no oversized pistons available for service. Refer to Engine Mechanical Specifications .
scientia non olet · About LEMON Manuals