Ignition Coil Module Installation - Left Side - Off Vehicle

WARNING: This page is about a different variant/trim than selected.

Fig 1: Spark Plug

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the left spark plugs.
Tighten: Tighten the spark plugs to 15 N.m (11 lb ft).

Fig 2: Spark Plug Boot

Courtesy of GENERAL MOTORS CORP.

Apply a small amount of dielectric grease GM P/N 12345579, (Canadian P/N 1974984), to each spark plug boot (1) of the ignition coil assembly.

Fig 3: Ignition Coil Assembly

Courtesy of GENERAL MOTORS CORP.

Fig 4: Left Ignition Coil Assembly Bolts & Studs

Courtesy of GENERAL MOTORS CORP.

Install the left ignition coil assembly bolts (708) and ball studs (709).
Tighten: Tighten the left ignition coil assembly bolts (708) and ball studs (709) to 10 N.m (89 lb in).

Fig 5: Ignition Coil Assembly Cover

Courtesy of GENERAL MOTORS CORP.