LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Mechanical - 4.4L (2 Of 5)) >> On-Vehicle Repair Instructions (Part 2) >> Valve Lifter Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Ensure the crankshaft is in the top dead center (TDC) position for the number one cylinder.
    2. Fig 1: View Of Valve Lifter
    GM240801Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Valve Lifter Priming Notice .
  2. Fill the SHLA with clean engine oil. Refer to Sealers, Adhesives, and Lubricants for the correct part number. Take precautions to prevent scratching the pivot sphere area (1) of the SHLA.
    3. Fig 2: View Of Right Valve Lifter
    GM928626Courtesy of GENERAL MOTORS CORP.
  3. Lubricate the SHLA bores of the cylinder head with clean engine oil. Refer to Sealers, Adhesives, and Lubricants for the correct part number.
  4. Install the SHLA into the bores.
  5. Install the right valve rocker arms. Refer to Valve Rocker Arm Replacement - Right Side .
scientia non olet · About LEMON Manuals