LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Mechanical - 4.4L (2 Of 5)) >> On-Vehicle Repair Instructions (Part 2) >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Flywheel
    GM1346206Courtesy of GENERAL MOTORS CORP.
  1. Install the engine flywheel.
  2. Apply sealant to the engine flywheel bolts. Refer to Sealers, Adhesives, and Lubricants for the correct part number.
  3. Install the engine flywheel bolts finger tight.
  4. Use a Snap-On™ A144A Flywheel Turner or equivalent to prevent the engine from rotating.
    5. NOTE: Refer to Fastener Notice .
  5. Tighten the engine flywheel bolts.

    Tighten: 

    • Tighten the flywheel bolts a first pass to 30 N.m (22 lb ft).
    • Tighten the flywheel bolts a final pass, an additional 50 degrees using the J 45059  .

  6. Install the transmission assembly. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals