LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Mechanical - 4.4L (2 Of 5)) >> On-Vehicle Repair Instructions (Part 2) >> Camshaft Position Actuator Replacement - Bank 1 (Right Side) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Camshaft Alignment Pin Hole On Back Of Actuator
    GM1285137Courtesy of GENERAL MOTORS CORP.
  1. Locate the camshaft alignment pin hole (2) on the back of the actuator. This hole will mate with the camshaft alignment pin.
    2. Fig 2: Locating Timing Mark On Front Of Actuator
    GM1272586Courtesy of GENERAL MOTORS CORP.
  2. Locate the timing alignment mark (1) on the front of the actuator.
    3. Fig 3: Identifying Camshaft Sprockets & Related Components
    GM1276769Courtesy of GENERAL MOTORS CORP.
  3. Engage the actuator timing gear teeth with the secondary timing chain ensuring that the actuator alignment mark (3) corresponds with the paint mark created on the chain link.
  4. Slide the actuator over the camshaft alignment pin and install the actuator onto the camshaft.
  5. Install the right exhaust camshaft position actuator oil control valve. Refer to Camshaft Position Actuator Oil Control Valve Replacement - Bank 1 (Right Side) Exhaust .
scientia non olet · About LEMON Manuals