LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Mechanical - 4.4L (2 Of 5)) >> Off-Vehicle Repair Instructions (Part 1) >> Starter Removal - Off Vehicle

Starter Removal - Off Vehicle

WARNING: This page is about a different variant/trim than selected.
    Fig 1: ECT Sensor
    GM1714261Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine coolant temperature (ECT) sensor from the rear of the right cylinder head.
    2. Fig 2: Knock And Crankshaft Position Sensor
    GM1656789Courtesy of GENERAL MOTORS CORP.
  2. Remove the knock and crankshaft position sensor wiring harness bolt.
  3. Disconnect the knock and crankshaft position sensor wiring harness connectors from the knock sensors and the crankshaft position sensor.
  4. Disconnect the knock and crankshaft position sensor wiring retainers from the attaching points in the center and side of block valley.
  5. Remove the knock and crankshaft position sensor wiring harness.
    6. Fig 3: Knock Sensor Bolts
    GM1656791Courtesy of GENERAL MOTORS CORP.
  6. Loosen the knock sensor bolts.
  7. Remove the knock sensors.
    8. Fig 4: Crankshaft Position Sensor Bolt
    GM1656794Courtesy of GENERAL MOTORS CORP.
  8. Remove the crankshaft position sensor bolt.
  9. Remove the crankshaft position sensor.
    10. Fig 5: Crankshaft Position Sensor O-Ring
    GM1761739Courtesy of GENERAL MOTORS CORP.
  10. Remove and discard the crankshaft position sensor O-ring.
    11. Fig 6: Starter Motor Bolts
    GM1656788Courtesy of GENERAL MOTORS CORP.
  11. Remove the starter motor bolts.
  12. Remove the starter motor and starter motor wiring harness.
scientia non olet · About LEMON Manuals