Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
- Inspect the exterior of the oil pan for the following:
- Damage to the transmission mounting hole threads (1)
- Damage to the engine oil level switch/temperature sensor bolt hole threads (2)
- Damage to the engine oil level switch/temperature sensor hole (3)
- Damage to the exterior of the oil pan (4)
- Damage to the oil pan drain plug hole threads (5)
- Damage to the mounting hole threads (6) for the front differential
- Damage to the oil pan bolt holes (7)
- Inspect the interior of the oil pan for the following:
- Damage to the oil pan gasket sealing surface (1)
- Damage to the oil pan-axle pass through (2)
- Damage or blockage to the oil pan interior (3)
- Damage to the mounting hole threads (4) for the front differential
- Damage to the engine oil level switch/temperature sensor mounting bore (5)
- Repair or replace the oil pan as necessary.