LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.4L (3 Of 5)) >> Off-Vehicle Repair Instructions (Part 2) >> Oil Pan Assemble - Off Vehicle

Oil Pan Assemble - Off Vehicle

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Oil Level Switch/Temperature Sensor O-Ring
    GM1761729Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW O-ring on the engine oil level switch/temperature sensor.
  2. Fig 2: View Of Oil Level Sensor
    GM1351928Courtesy of GENERAL MOTORS CORP.
  3. Install the engine oil level switch/temperature sensor.
  4. NOTE: Refer to Fastener Notice .
  5. Install the engine oil level switch/temperature sensor bolt.

    Tighten:  Tighten the engine oil level switch/temperature sensor bolt to 10 N.m (89 lb in).

  6. Fig 3: View Of Oil Pan Drain Plug
    GM1351926Courtesy of GENERAL MOTORS CORP.
  7. Install a NEW O-ring on the oil pan drain plug.
  8. Install the oil pan drain plug.

    Tighten:  Tighten the oil pan drain plug to 25 N.m (18 lb ft).