LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Mechanical - 4.4L (3 Of 5)) >> Off-Vehicle Repair Instructions (Part 2) >> Crankshaft and Bearing Removal - Off Vehicle >> Crankshaft Bearing Removal Procedure

Crankshaft Bearing Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Prepare a piece of cardboard, or equivalent, numbered one to five for bearing identification. Main bearing journals are numbered from the front of the engine.
    2. Fig 1: View Of Thrust Bearing
    GM947631Courtesy of GENERAL MOTORS CORP.
  2. Remove the upper crankshaft bearing halves from the cylinder block. Note the position of the thrust bearing (1) at the number three journal.
  3. Place the upper main bearing halves on the cardboard in the correct positions. Note that the number three bearing is the thrust bearing.
    4. Fig 2: View Of Lower Main Bearing Half
    GM947640Courtesy of GENERAL MOTORS CORP.
  4. Remove the lower main bearing halves from the lower crankcase.
  5. Place the lower main bearing halves in the correct positions on the cardboard.
scientia non olet · About LEMON Manuals