LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - 4.6L (LH2) - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Replacement - Bank 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Ignition Coil Cover - Bank 2
    GM1235153Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Remove the ignition coil cover from the cam cover by lifting straight up.
    3. Fig 2: View Of Ignition Coils
    GM1283865Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the ignition coil wiring harness electrical connector from the coil that needs to be replaced.
  4. Remove the ignition coil retaining bolt.
  5. Carefully remove the ignition coil assembly.
scientia non olet · About LEMON Manuals