Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Ignition Coils

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Ensure that the spark plug seals are in place when installing the ignition coil.

NOTE: Refer to Fastener Notice .

Install the ignition coil retaining bolt.
Tighten: Tighten the ignition coil retaining bolt to 10 N.m (89 lb in).
Reconnect the ignition coil electrical connector.

Fig 2: View Of Ignition Coil Cover - Bank 1

Courtesy of GENERAL MOTORS CORP.

Install the ignition coil cover to the cam cover.
Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .