LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - 4.6L (LH2) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Emissions Purge Valve Line & Electrical Connector
    GM1239219Courtesy of GENERAL MOTORS CORP.
  1. Loosen the fuel cap in order to relieve the system pressure.
  2. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  3. Disconnect the evaporative emission (EVAP) canister purge valve electrical connector (1).
  4. Disconnect the EVAP purge pipe (2) from the EVAP canister purge valve.
    5. Fig 2: View Of EVAP Canister Purge Valve Retaining Bolt
    GM1242773Courtesy of GENERAL MOTORS CORP.
  5. Remove the EVAP canister purge valve retaining bolt.
  6. Remove the EVAP canister purge valve from the water housing.
scientia non olet · About LEMON Manuals