LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - 4.6L (LH2) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Be sure to install a new O-ring on the EVAP purge valve.
  1. Lubricate the O-ring with clean engine oil.
    2. Fig 1: View Of EVAP Canister Purge Valve Retaining Bolt
    GM1242773Courtesy of GENERAL MOTORS CORP.
  2. Install the EVAP canister purge valve to the water housing.
    3. NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister purge valve retaining bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

    4. Fig 2: View Of EVAP Emissions Purge Valve Line & Electrical Connector
    GM1239219Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP purge pipe (2) to the EVAP canister purge valve.
  5. Connect the EVAP canister purge valve electrical connector (1).
  6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals