LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - 4.6L (LH2) - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Camshaft Sensor
    GM1247907Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Inspect the camshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.
  1. Lubricate the camshaft sensor O-ring with engine oil.
    2. NOTE: Refer to Fastener Notice .
  2. Install the left bank exhaust camshaft position sensor (4) and retaining bolt.

    Tighten:  Tighten the retaining bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Left Camshaft Position Sensor Electrical Connector
    GM887907Courtesy of GENERAL MOTORS CORP.
  3. Reconnect the camshaft sensor electrical connector (2).
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  5. Operate the engine and inspect the camshaft sensor for engine oil leaks.
scientia non olet · About LEMON Manuals