LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - 4.6L (LH2) - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Right Camshaft Position Sensor Electrical Connector
    GM887905Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
    2. IMPORTANT: When disconnecting more than one sensor, mark the connectors to ensure correct re-installation. The electrical connectors are physically interchangeable, however, they must be installed to the correct sensor.
  2. Disconnect the electrical connector from the right bank exhaust camshaft position sensor (2).
    3. Fig 2: Locating Camshaft Sensor
    GM1247907Courtesy of GENERAL MOTORS CORP.
  3. Remove the camshaft sensor retaining bolt.
  4. Remove the right bank exhaust camshaft sensor (1).
scientia non olet · About LEMON Manuals