LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 4.6L (LH2) - 2 Of 5) >> On-Vehicle Repair Instructions (Part 2) >> Valve Stem Oil Seal and Valve Spring Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Using J 38820 To Replace Valve Seal
    GM616165Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the valve stem and the inner diameter of the new seal with clean engine oil.
    2. IMPORTANT: Install a seal protector over the valve stem prior to installing the valve stem seal.
  2. Using a twisting pushing motion install the NEW valve stem seal using the J 38820  .
  3. Install the valve spring retainer and valve spring.
    4. Fig 2: View Of Base Plate Installed Over The Spark Plug Hole For Changing Valve Stem Seal
    GM650537Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Compressed Valve Spring Caution .
  4. Swing the arm over the valve spring retainer and tighten the swivel nut of the J 44211  (2) down only enough to allow access for installation of the valve locks.
  5. Using a magnet, position the valve locks to the valve stem retainer groove. Grease can be used to hold the locks in place.
  6. Remove the swivel nut and arm of the J 44211  (2).
  7. Install the arm and swivel nut of the J 44211  (2) over the stud of any other valves being serviced and repeat removal steps 12-17 and installation steps 1-7.
  8. Relieve the air pressure to the cylinder being serviced.
  9. Remove the J 39313  (1) from the spark plug hole.
  10. Remove the base plate of the J 44211  (2).
  11. Install the spark plug. Refer to Spark Plug Replacement .
  12. Repeat removal steps 7-14 and installation steps 1-11 on any other cylinders being serviced.
  13. Install the left camshafts. Refer to Camshaft Replacement - Left Side .
    14. Fig 3: View Of EN 46326 Installed To Engine Block
    GM1275654Courtesy of GENERAL MOTORS CORP.
  14. Remove the EN 46326  (1).
  15. Install the starter. Refer to Starter Motor Replacement (LH2) .
scientia non olet · About LEMON Manuals