LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 4.6L (LH2) - 2 Of 5) >> On-Vehicle Repair Instructions (Part 2) >> Valve Lifter Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Ensure the crankshaft is in the top dead center (TDC) position for the number one cylinder.
    2. Fig 1: View Of Valve Lifter
    GM240801Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Valve Lifter Priming Notice .
  2. Fill the SHLA with clean engine oil. Refer to Sealers, Adhesives, and Lubricants for the correct part number. Take precautions to prevent scratching the pivot sphere area (1) of the SHLA.
    3. Fig 2: View Of Left Valve Lifter
    GM928427Courtesy of GENERAL MOTORS CORP.
  3. Lubricate the SHLA bores of the cylinder head with clean engine oil. Refer to Sealers, Adhesives, and Lubricants for the correct part number.
  4. Install the SHLA into the bores.
  5. Install the left valve rocker arms. Refer to Valve Rocker Arm Replacement - Left Side .
scientia non olet · About LEMON Manuals