LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - 4.6L (LH2) - 2 Of 5) >> Off-Vehicle Repair Instructions (Part 1) >> Exhaust Camshaft Removal - Left Side - Off Vehicle

Exhaust Camshaft Removal - Left Side - Off Vehicle

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Exhaust Camshaft Bearing Cap Markings
    GM721578Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Bearing caps must remain with their original cylinder head and in their original location. Do not mix bearing caps.
  1. Observe the markings on the bearing caps. Each bearing cap is marked in order to identify its location. The markings have the following meanings:
    • The arrow points toward the front of the engine.
    • The "E" indicates the exhaust camshaft.
    • The number indicates the journal position from the front of the engine.
    2. Fig 2: View Of Left Exhaust Camshaft Bearing Cap Bolts
    GM928406Courtesy of GENERAL MOTORS CORP.
  2. Remove the left exhaust camshaft bearing cap bolts.
  3. Remove the left exhaust camshaft bearing caps. Store the bearing caps in a clean shop towel.
    4. Fig 3: View Of Left Exhaust Camshaft
    GM928409Courtesy of GENERAL MOTORS CORP.
  4. Remove the left exhaust camshaft. Place the camshaft in a secure location.
  5. Cover the camshaft with an oil soaked towel in order to prevent corrosion.
scientia non olet · About LEMON Manuals