Crankshaft Balancer Removal - Off Vehicle

Tools Required

• EN 46326  Flywheel Holding Tool
• J 24420-C  Harmonic Balancer Puller
• J 38416-2  Crankshaft Button

Fig 1: View Of Flywheel Holder
Courtesy of GENERAL MOTORS CORP.
1. Install the EN 46326  .
Fig 2: View Of Crankshaft Balancer Bolt
Courtesy of GENERAL MOTORS CORP.
2. Remove the crankshaft balancer bolt.
Fig 3: View Of J 38416-2 & J 24420-C
Courtesy of GENERAL MOTORS CORP.
3. Place the J 38416-2  into the end of the crankshaft.
4. Install the J 24420-C  on the crankshaft balancer.
Fig 4: View Of Crankshaft Balancer
Courtesy of GENERAL MOTORS CORP.
5. Remove the crankshaft balancer using the J 24420-C  .