Engine Noise Under Load

WARNING: This page is about a different variant/trim than selected.

Cause	Correction
Low oil pressure	Perform an oil pressure test. Refer to Oil Pressure Diagnosis and Testing . Repair or replace as required.
Detonation or spark knock	Verify the correct operation of the ignition system. Refer to Electronic Ignition (EI) System Diagnosis .
Loose torque converter bolts	Inspect the torque converter bolts and engine flywheel. Repair as required.
Cracked engine flywheel	Inspect the engine flywheel and bolts. Repair as required.
Excessive connecting rod bearing clearance	Inspect the following components, and repair as required: The connecting rod bearings The connecting rods The crankshaft
Excessive crankshaft bearing clearance	Inspect the following components, and repair as required: The crankshaft bearings The crankshaft journals The cylinder block crankshaft bearing bore