LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Transfer Case - BW 4479 - Service & Troubleshooting) >> Repair Instructions >> Transfer Case Fluid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: When performing the following procedure, use only hand tools to remove and install the drain and fill plugs.
    Fig 1: View Of Fill Plug
    GM927064Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the fill plug (6).
    3. Fig 2: View Of Drain Plug
    GM927063Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that an approved drain pan is used when draining the transfer case.
  3. Remove the drain plug (8).
  4. Allow the transfer case to drain completely.
scientia non olet · About LEMON Manuals