LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Transfer Case - BW 4479 - Service & Troubleshooting) >> Diagnostic Information and Procedures >> Transfer Case Shudder or Binding

Transfer Case Shudder or Binding

WARNING: This page is about a different variant/trim than selected.
Transfer Case Shudder or Binding

Cause Correction
DEFINITION: A shudder, binding, or a crop-hop while turning, which may cause tire scuffing.
Review the Symptoms - Transfer Case  and perform the necessary inspections.
Planetary differential
  1. Inspect the planetary differential pinion gears for the following conditions:
    • Chipped, bent or deformed teeth
    • Pinion gear bushings worn
    • Pinion gear thrust washers missing
    • Seized or binding pinion gears

      Refer to Cleaning and Inspection  in Transfer Case - BW 4476/79 Unit Repair.

  2. Inspect the planetary differential for deformation. Refer to Cleaning and Inspection  in Transfer Case - BW 4476/79 Unit Repair.
  3. Replace the planetary differential assembly if faulty. Refer to Transfer Case Disassemble  and Transfer Case Assemble  in Transfer Case - BW 4476/79 Unit Repair.
Thrust washer
  1. Inspect the thrust washer for seizure to the planetary differential.
  2. Replace the thrust washer if faulty and the mating component if damaged. Refer to Transfer Case Disassemble  and Transfer Case Assemble  in Transfer Case - BW 4476/79 Unit Repair.
Planetary differential not timed properly
  1. Inspect the planetary differential for being timed properly. Refer to Transfer Case Assemble  in Transfer Case - BW 4476/79 Unit Repair.
  2. Properly time the planetary differential gears. Refer to Transfer Case Assemble  in Transfer Case - BW 4476/79 Unit Repair.