Conditions for Clearing the MIL/DTC

WARNING: This page is about a different variant/trim than selected.

The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
Clear the MIL and the DTC with a scan tool.

DTC P1101

Step	Action	Yes	No
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Are any other DTCs set?	Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information	Go to Step 3
3	Turn OFF the ignition for 60 seconds. Start the engine. Test drive the vehicle under the conditions observed in the Freeze Frame/Failure records. Did the DTC fail this ignition?	Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information	Go to Inducing Intermittent Fault Conditions in Wiring Systems and Intermittent Conditions