Conditions for Clearing the MIL/DTC
WARNING: This page is about a different variant/trim than selected.
- The control module turns OFF the MIL after 6 consecutive ignition cycles that the diagnostic runs and does not fail.
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Clear the MIL and the DTC with a scan tool.
DTC P0700
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Observe the DTC Information with a scan tool and record any powertrain DTCs other than DTC P0700. Did you complete the action? |
Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | - |