LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System - 4.4L - DTC P0506 To P2544) >> DTC P1516, P2101, P2119, or P2176 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Turn OFF the ignition before inserting fingers into the throttle bore. Unexpected movement of the throttle blade could cause personal injury.
  1. Inspect the throttle body for the following conditions:
    • A throttle blade that is NOT in the rest position
    • A throttle blade that is binding when opening or closing
    • A throttle blade that is free to move in the open or closed positions WITHOUT spring pressure
    • If a condition is found, replace the throttle body.
    2. IMPORTANT: Disconnecting the throttle body harness connector causes additional DTCs to set.
  2. Ignition OFF, disconnect the harness connector at the throttle body.
  3. Ignition ON, verify that a test lamp does not illuminate between motor control circuit 1 terminal 4, and ground.
    • If the test lamp illuminates, test the motor control circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Ignition ON, verify that a test lamp does not illuminate between motor control circuit 2 terminal 6, and ground.
    • If the test lamp illuminates, test the motor control circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Ignition ON, verify that a test lamp does not illuminate between motor control circuit 1 terminal 4 and B+.
    • If the test lamp illuminates, test the motor control circuit for a short to ground. If the circuit tests normal, replace the ECM.
  6. Ignition ON, verify that a test lamp does not illuminate between motor control circuit 2 terminal 6 and B+.
    • If the test lamp illuminates test the motor control circuit for a short to ground. If the circuit tests normal, replace the ECM.
  7. Ignition OFF, allow sufficient time for the ECM to completely power down. Connect a DMM between the motor control 1 terminal 4 and ground.
    8. IMPORTANT: When measuring peak voltage, ensure that the DMM is on the proper voltage scale and that the response time is set to 1 ms.
  8. Measure for B+ on the motor control 1 circuit terminal 4 as the ignition is turned ON.
    • If the peak voltage is not within 1 volt of B+, test the circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  9. Ignition OFF, allow sufficient time for the ECM to completely power down.
  10. Measure for B+ on the motor control 2 circuit terminal 6 as the ignition is turned ON.
    • If the peak voltage is not within 1 volt of B+, test the circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  11. If all circuits test normal, replace the throttle body.
scientia non olet · About LEMON Manuals